how to install speedy sleeves
Posted: Sat Feb 04, 2006 10:26 am
When you have a worn axle shaft you can use a speedy sleeve to update the shaft as new. This helps keeping the water out off the wheel bearings and the grease in its place [ not in the brake drum]
First you have to remove the brake drum with the wheel bearings
Check the the flange where the grease retainer runs if it has wear place a speedy sleeve.
To place a speedy sleeve you have to make a tool of 2 inch inner diameter pipe.
This has to be longer then the shaft on the axle .
see pictures.
with this tool you can place your speedy sleeve very easy.
tool on shaft
speedy sleeve in place and ready
First you have to remove the brake drum with the wheel bearings
Check the the flange where the grease retainer runs if it has wear place a speedy sleeve.
To place a speedy sleeve you have to make a tool of 2 inch inner diameter pipe.
This has to be longer then the shaft on the axle .
see pictures.
with this tool you can place your speedy sleeve very easy.
tool on shaft
speedy sleeve in place and ready