Page 1 of 1
Mounting of hand starter unit
Posted: Wed Oct 18, 2006 8:36 pm
by leo verhagen
Can anyone tell me how the handstart unit (left on photo) is connected to the tube (right on photo) and how this tube is mounted to the crossmember.
A detailed discription or even better a photo is highly appeciated :!:
(I do have GPA TM's and GPA parts list drawing but I can't figure it out :o )
Posted: Thu Oct 19, 2006 7:06 am
by GlennV
Hi Leo,
it is mounted in the bracket on the side of the chassis (the one with all the holes in it).
You can barely see it in the picture, but hopefully it helps ! :wink:
Best regards,
Glenn
Hand cranck
Posted: Thu Oct 19, 2006 3:00 pm
by bobassel
Leo
It is a little tricky thing to do!
Hard to explain on this forum.
When you are in that stage I will gladly assist you.
Bob
Posted: Thu Oct 19, 2006 6:20 pm
by leo verhagen
Thanks for your replies, I'm working on this part right now Bob, but from Glenn I learned now the right part is fitted on the frame and not on the cross member and that is a part of the information I needed.