Page 1 of 1
PTO pulley wanted
Posted: Wed Oct 08, 2008 6:46 am
by Cees
Who can help my frend Manny Rodgers, his PTO pulley (GPA-15471) is badley worn out and need a good one.
Cees
Re: PTO pulley wanted
Posted: Wed Oct 08, 2008 7:55 am
by Jan Roelse
Hi Cees,
If the problem is "the sheet metal part of the pulley assy.", you can use a good used or "nos" crankshaft pully (same size!) with the innerpart removed with help of a lathe.
New rivets, and the job is done!
Regards,
Jan
Re: PTO pulley wanted
Posted: Wed Oct 08, 2008 2:56 pm
by Cees
Jan,
It is not the sheet metal it is the inner part + the rivets hole's are worn out.
Cees
Re: PTO pulley wanted
Posted: Wed Oct 08, 2008 4:56 pm
by Jan Roelse
Hi Cees,
If Manny wants to restore/safe the old pulley he can drill maybe new holes. Let the old ones or fill it up with some steel by welding or else.
I had the same problem years ago. After nearly 30 year its still in running condition.
I sure know... "NOS" is the best!!! :-) Hope someone can help.
Regards,
Jan
Re: PTO pulley wanted
Posted: Wed Oct 08, 2008 6:18 pm
by peterverhoeven
Hi Jan and Cees,
I think Jaap has them I talked about PTO parts with him a few months ago.
I am not 100 % sure but if I understood it he must have those parts.
Kind regards Peter
Re: PTO pulley wanted
Posted: Thu Oct 09, 2008 6:10 pm
by Cees
Thanks Peter,
I phoned Jaap and he is checking his warehous but he don't think he has got one.
Cees