Page 1 of 1
Surf shield ?
Posted: Sun Apr 03, 2011 4:09 pm
by David Welch
What holds the surf shield in place when it is in the forward position. Did it chance during production?
Any pictures ?
Thanks
David
Re: Surf shield ?
Posted: Sun Apr 03, 2011 5:17 pm
by Donovan
David,
There are two shoulder bolts that stick up and catch the surf shield (there are special brackets on the surf shield). I will see if I have any pictures and post.
Donovan.
Re: Surf shield ?
Posted: Sun Apr 03, 2011 6:27 pm
by bobassel
Hi David
Loosen the wingnuts and turn the surfshield 180 degr. forward and push the lips under the bolts as on the attached picture.
Fasten the wingnuts.
Bob
Re: Surf shield ?
Posted: Sun Apr 03, 2011 11:33 pm
by David Welch
Is it at 3/8 shouldered bolt . How high is the shoulder from the rail to the bottom of the bolt head
Re: Surf shield ?
Posted: Tue May 17, 2011 7:28 am
by richardfs
Hi
Can any one give me a length of the shoulder on the bolt?
(How long the un machined part of the bolt is that the surf shield clips around)
I need to make a couple for my GPA.
Best regards
Richard