Sealing boots : how to place them

[melusina53]

Hello, how do you place the sealing boot?
on the inside or on the outside, and how do you fit it on the rod?

[melusina53]

http://imageshack.us/photo/my-images/43/dscf0028jv.jpg/

[leo verhagen]

I hope this photo helps:

[melusina53]

It helps a lot :-)
thank you
If you have other photos of how you did it, it would help even more

[Steve Barber]

To save wear on the boot I did not use a clamp. I used two nylon "wire ties" aka "cable ties and cinched them down to where they are snug but not tight. I use wheel bearing grease and lube the drag link so that it slides in and out allowing the boot allowing the boot to remain in its normal shape and position. I get very little leakage when swimming by using this method. I believe that this will extend the life of my boot by not flexing it every time the GPA makes a turn.

[leo verhagen]

Here are some more photos to show you how I did it.

First you must make sure you have a special tool that fits inside the drag link:



Mine was made out of metal, but you can also make one out of wood or plastic I think.

Put the rubber boot in hot water and let it warm up for a while.

Then put some lubricant (like soap) on the special tool and the drag link.
Now it is easy to pull the boot over the draglink. Make sure you put it on the right side (in the right direction).
I did'nt clamp my boot either, just lubricated it with lithium grease.

To finish a photo how it looks on the inside:


I hope this helps!

[melusina53]

it helps and a lot, too :-)
I am the wife and translator : husband and meccanic are very very grateful to you all :-)

[melusina53]

I have found a set of originale seal boots, here are the photos


By fayruz at 2012-03-24


By fayruz at 2012-03-24

[Bob leguit]

Melusina,

if you still have your doubts about the original, there are also new for sale.


http://fordgpa.xsbb.nl/viewtopic.php?f= ... s#p8079239

Bob.

[melusina53]

I have also purchased a new set :-) and the tool to put them on the GPA

the shape of the new ones and the originals is slightly different, I am only the wife-translator : the husband GPA owner and his friend meccanic decide :-) what to do.