Wiper Vacuum Line

[GPA2196]

Hello,

I'm getting ready to do the vacuum line to the wiper. I have the intake manifold with two plugs (no center plug) Which plug should I hook the line to? I assume it is steel to where it passes up to the deck and then goes rubber to the steel line on the windshield to allow it to fold down? There is a hole on the air duct forward of the bigger one on the rear which is where my front harness wires are going through... is the forward smaller hole for the vacuum line? Does anybody have pictures of how this should look under the hood?

Many Thanks,
Tony

[GlennV]

Hi Tony,

i just used a standard fitting with on one side the thread and on the other side a tube ... (your local car shop or compressor store should have these pieces) on which you just put the flexibal rubber hose through the side panel and through the big hole on the left front side of the dash panel.

Hopefully this picture helps ....



Glenn